124 DIA GNOSTICS
7.1.7 SPEED LOOP MONITOR / Tachogenerator volts monitor PIN 129
Note. There is an unfiltered % version of this value on hidden PIN 716.
7.1.8 SPEED LOOP MO NIT OR / Motor RPM monitor PIN 1 30
Note. 130)MO T OR RPM MON will only be accurate w hen
1) In A V F feedback mode 18)RA TED ARM V OLTS corresponds to 6)DESIRED MA X RPM, for
100% speed.
2) In ANALO G T A CHO feedback mode 8)M A X TA CH O V OLTS corresponds to 6)DESIRED MA X
RPM, for 100 % speed.
Note. There is an unfiltered version of this value on hidden PIN 717.
7.1.9 SPEED LOOP MONIT OR / Encoder RPM monitor PIN 132
There is a % equivalent of this signal on hidden pin 709)MOT OR RPM %.
See also 6.1.10.3 ENCODER SC ALING / Motor / encoder speed ratio PIN 12.
7.1.10 SPEED LOOP MO NIT OR / Speed feedback % monitor PIN 131
Note. There is an unfiltered version of this value on hidden PIN 715.
SPEED LO OP MONITOR 3
130)M OTOR RPM MON
130)M OTOR RPM MON
0 RPM
PARA METER RANGE PIN
MO TOR RPM M ON + /- 7500 RPM 130
Shows the value of the revs per minute of
the motor.
R R
SPEED LO OP MONITOR 3
131)SPEED FBK % MO N
131)SPEED FBK % MO N
0.00 %
PARA METER RANGE PIN
SPEED FBK % MO N + /-300.00% 13 1
Shows the value of the speed feedback as
a % of full scale.
R
R
SPEED LO OP MONITOR 3
132)ENCODER RPM M ON
132)ENCODER RPM M ON
0 RPM
PARA METER RANGE PIN
ENCODER RPM MON + /- 7500 RPM 132
Shows the value of the encoder revs per
minute independently of feedback type.
R R
SPEED LO OP MONITOR 3
129)T A CHO V OLTS MO N
129)T A CHO V OLTS MO N
0.00 Volts
PARA METER RANGE PIN
T A CH VOLTS MON + /- 220.00 Volts 129
Shows the average DC tachogenerator
voltage independently of feedback type.
R
R
To Next Page
Loading...