CHA NGE PARA METERS 77
JO G CRA WL SLA CK 3
43)JO G/SLA CK RA MP
JO G CRA WL SLA CK 3
37)JO G SPEED 1
JO G CRA WL SLA CK 3
42)JO G MODE SELECT
JO G CRA WL SLA CK 3
38)JO G SPEED 2
JO G CRA WL SLA CK 3
39)SLA CK SPEED 1
JO G CRA WL SLA CK 3
40)SLA CK SPEED 2
JO G CRA WL SLA CK 3
41)CRA WL SPEED
CH A NGE PARA METERS 2
JO G CRA WL SLA CK 3
R
R
R
R
R
R
R
R
6.3 CHANGE PARAMETERS / JOG CRAWL SLACK
JO G / CRA WL / SLA CK PIN numbers range 37 to
43.
This menu provides adjustment for parameters
associated with jogging, slack take up and
cra wling.
See 6.3.5 JOG CRA WL SLACK / Jog mode select
PIN 42. This gives a table showing the 8 modes of
operation available.
Their are 2 hidden PINs that provide output flags
as follow s
689)IN J OG FLA G.
This is high during the jogging process, it goes low
after the ramp has returned to the prevailing run
level.
714)IN SLA C K FLAG.
This is high during the slack take up process, it
goes lo w after the ramp has returned to the
prevailing run level.
This flag is useful in centre winding applications for
controlling the tension enable. See APPLIC A TIO NS M A NU AL.
To Next Page
Loading...