Chapter 7: Maintenance
7/20
Operators & Maintenance Manual GENIUS Compact Version UK 0.1 © BESTnv
BESTnv Industrial Research BV, Marinus van Meelweg 20, 5657 EN, EINDHOVEN, THE NETHERLANDS
General tel. +31 (40) 292 2622 - Service tel. +31 (40) 292 2620 - Fax. +31 (40) 292 2633 - Email: service.BESTnv@bestnv.com
- a) Put Loctite 222 on each M5 setscrew before screwing in, and never screw too tight.
- b) Put Loctite 243 on each M10 tap screw, and inside the screw hole before screwing in.
8. Take return axle assembly with new rollers and place it back carefully, so as not to damage the detection
belt. Screw the fi xing bolts back in.
7. Take new rollers out of spare parts package and mount new rollers and bearing blocks:
Remark: - Make sure to clean all screws and holes before applying Loctite 222 (M5
screws) or Loctite 243 (M10 screws).
9. Screw out the supporting bolts until they touch the return axle assembly and then screw out one extra
1/2 turn.
To Next Page
Loading...