Cisco 8811 Administration Guide

Possible explanation and actionDescriptionMessage
From Cisco Unified Operating System
Administration, check that the following files
are located within subdirectories in the TFTP
File Management:
•
Located in subdirectory with same name
as network locale:
◦
tones.xml
•
Located in subdirectory with same name
as user locale:
◦
glyphs.xml
◦
dictionary.xml
◦
kate.xml
One or more localization files could not be
found in the TFTPPath directory or were not
valid. The locale was not changed.
Error update locale
The configuration file for a phone is created
when the phone is added to the Cisco Unified
Communications Manager database. If the
phone does not exist in the Cisco Unified
Communications Manager database, the TFTP
server generates a CFG File Not Found
response.
•
Phone is not registered with Cisco
Unified Communications Manager.
You must manually add the phone to
Cisco Unified Communications Manager
if you are not allowing phones to
autoregister. See Phone Addition
Methods, on page 70 for details.
•
If you are using DHCP, verify that the
DHCP server is pointing to the correct
TFTP server.
•
If you are using static IP addresses,
check configuration of the TFTP server.
The name-based and default configuration
file was not found on the TFTP Server.
File not found <Cfg File>
No impact; the phone can still register to Cisco
Unified Communications Manager.
This message displays on the phone when
the Cisco Unified Communications Manager
cluster is not in secure mode.
File Not Found <CTLFile.tlv>
The phone remains idle until it is power cycled
or until you reset the DHCP address.
The phone is configured to release the IP
address.
IP address released
None. This message is informational only.
The ITL file was not installed previously.
The ITL file is installed in the phone.ITL installed
Cisco IP Phone 8800 Series Administration Guide for Cisco Unified Communications Manager
205
Cisco IP Phone Status

Cisco 8811 Specifications

General

Ethernet Ports	2 x 10/100/1000
Lines Supported	5
Speakerphone	Yes
Headset Port	Yes
USB Port	No
Bluetooth	No
Wi-Fi	No
Resolution	800 x 480 pixels
PoE	Yes, IEEE 802.3af Class 2
Audio Codec Support	G.711, G.722, G.729, iLBC
Protocols	SIP
Display	5-inch, 800 x 480 pixels
Headset Jack	RJ9
Weight	1.1 kg