Cisco ASR 1000

Contents
xi
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
OL-14127-08
CHAPTER 14 Overview of the Serial SPAs 14-1
Release History 14-1
Supported Features 14-2
Restrictions 14-4
Supported MIBs 14-5
Displaying the SPA Hardware Type 14-7
Examples of the show interfaces Command 14-7
Examples of the show controllers Command 14-8
CHAPTER 15 Configuring the 8-Port Channelized T1/E1 SPA 15-1
Configuration Tasks 15-1
Required Configuration Tasks 15-1
Setting the Card Type 15-2
Enabling the Interfaces on the Controller 15-4
Verifying Controller Configuration 15-5
Setting the IP Address 15-6
Verifying Interface Configuration 15-6
Specifying the Interface Address on a SPA 15-6
Optional Configurations 15-7
Configuring Framing 15-8
Configuring Encapsulation 15-9
Configuring the CRC Size for T1 15-10
Configuring FDL 15-11
Invert Data on the T1/E1 Interface 15-11
Changing a Channel Group Configuration 15-12
Configuring QoS Features on Serial SPAs 15-12
Saving the Configuration 15-13
Verifying the Interface Configuration 15-13
Verifying Per-Port Interface Status 15-13
Configuration Examples 15-14
Framing and Encapsulation Configuration Example 15-14
CRC Configuration Example 15-14
Facility Data Link Configuration Example 15-15
Invert Data on the T1/E1 Interface Example 15-15
CHAPTER 16 Configuring the 2-Port and 4-Port Channelized T3 SPAs 16-1
Configuration Tasks 16-1
Required Configuration Tasks 16-2