Cisco ASR 1000

Contents
xii
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
OL-14127-08
Configuring the T3 Controller 16-2
Configuring the Logical T1 Interfaces 16-3
Verifying T3 Controller Configuration 16-5
Verifying Interface Configuration 16-6
Specifying the Interface Address on a SPA 16-7
Optional Configurations 16-8
Configuring Data Service Unit Mode 16-8
Configuring Maintenance Data Link 16-9
Configuring Encapsulation 16-11
Configuring T3 Framing 16-13
Configuring FDL 16-13
Configuring Scramble 16-15
Saving the Configuration 16-16
Verifying the Interface Configuration 16-16
Verifying Per-Port Interface Status 16-16
Configuration Examples 16-17
DSU Configuration Example 16-18
MDL Configuration Example 16-18
Encapsulation Configuration Example 16-18
Framing in Unchannelized Mode Configuration Example 16-19
Facility Data Link Configuration Example 16-19
Scrambling Configuration Example 16-19
Creating a Multilink Bundle Configuration Example 16-19
Assigning a T1 Interface to a Multilink Bundle Configuration Example 16-20
CHAPTER 17 Configuring the 2-Port and 4-Port Clear Channel T3/E3 SPAs 17-1
Configuration Tasks 17-1
Required Configuration Tasks 17-2
Setting the Card Type 17-2
Setting the IP Address 17-3
Verifying Controller Configuration 17-3
Verifying Interface Configuration 17-4
Specifying the Interface Address on a SPA 17-5
Optional Configurations 17-5
Configuring Data Service Unit Mode 17-5
Configuring Maintenance Data Link 17-7
Configuring Scramble 17-9
Configuring Framing 17-11
Configuring Encapsulation 17-12