Cisco Catalyst 2950 Command Reference

2-274
Catalyst 2950 and Catalyst 2955 Switch Command Reference
0L-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
show auto qos
These are examples of output from the show auto qos command when auto-QoS is disabled on the
switch:
Switch> show auto qos
AutoQoS not enabled on any interface
These are examples of output from the show auto qos interface interface-id command when auto-QoS
is disabled on an interface:
Switch> show auto qos interface fastethernet0/1
AutoQoS is disabled
Related Commands Command Description
auto qos voip Automatically configures QoS for VoIP within a QoS domain.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz