Cisco Catalyst 2950

2-292
Catalyst 2950 and Catalyst 2955 Switch Command Reference
0L-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
show controllers ethernet-controller
This is an example of output from the show controllers ethernet-controller longreachethernet0/4 cpe
command. It shows the statistics of the LRE chipset and the all the LRE ports on the CPE. For this
example, Table 2-13 describes the LRE Enet Stats on CPE fields, and Table 2-14 describes the CPE Fast
Ethernet Port fields.
Switch# show controllers ethernet-controller longreachethernet0/4 cpe
LRE Enet Stats on CPE:
Transmit Receive
0 Bytes 0 Bytes
0 Frames 0 Frames
0 Broadcast frames
0 Pause frames 0 Pause frames
0 1 collision frames 0 Alignment errors
0 Multiple collisions 0 Collisions and Runts
0 Late collisions 0 Oversize frames
0 Excessive collisions 0 FCS errors
0 Deferred frames
0 Carrier sense errors
CPE Fast Ethernet Port: 1
Transmit Receive
0 Bytes 0 Bytes
0 Good Bytes
0 Unicast Frames 0 Unicast Frames
0 Multicast Frames 0 Multicast Frames
0 Broadcast Frames 0 Broadcast Frames
0 Dropped Frames 0 Dropped Frames
0 Pause Frames 0 Pause Frames
0 Collision Frames 0 Alignment Errors
0 One Collision Frames 0 Fragments
0 Multiple Collisions 0 Undersize Frames
0 Late Collisions 0 Oversize Frames
0 Excess Collisions 0 FCS errors
0 Frame Discard 0 Excess Size Discards
0 Deferred Frames 0 Jabbers
0 Source Address Chang
0 Symbol Errors
0 64 Byte Frames
0 65-127 Byte Frames
0 128-255 Byte Frames
0 256-511 Byte Frames
0 512-1023 Byte Frames
0 1024-1522 Byte Frame