Cisco Catalyst 2950 Command Reference

2-318
Catalyst 2950 and Catalyst 2955 Switch Command Reference
0L-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
show controllers lre status
Related Commands Command Description
margin Specifies the margin value used to determine link quality during
LRE rate selection.
show controllers lre sequence Displays the sequence running on a specific switch LRE port.
show controllers lre profile Displays information about the LRE profiles available on the
switch.
show controllers lre cpe Displays the actual values of the LRE link on a specific switch
LRE port.
show controllers lre admin Displays the administrative settings of the LRE link on a specific
switch LRE port.
show controllers lre profile Displays information about the LRE profiles available on the
switch.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz