Cisco Catalyst 2950

2-317
Catalyst 2950 and Catalyst 2955 Switch Command Reference
0L-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
show controllers lre status
Port Sequence Status Profile
----- ----------------------- -------------- ---------------
Lo0/1 LRE-SEQ-DOWNSTREAM Converged LRE-15
Lo0/2 N/A N/A N/A
Lo0/3 LRE-SEQ-SYM Converged LRE-15
This is an example of output from the show controllers lre status interleave command:
Switch# show controllers lre status interleave longreachethernet0/2
Port Link Profile Line Rate Block Size Delay(mSec)
DS US DS US DS US
------ ---- ---------------- -------------- ----------- -------------
Lo0/2 UP LRE-6 6.250 6.250 16 16 20.316 20.316
This is an example of output using the details keyword to obtain further information about the sequence:
Switch# show controllers lre status sequence detail
Lo0/1 :
Sequence:LRE-SEQ-DOWNSTREAM Status:Converged Attempts:1
Profile:LRE-15 Convergence Time: 00:01:54
Rate-Selection:Enabled Locking:Not-Configured
Downstream Margin:2 Upstream Margin:0
Lo0/2 :
Sequence:N/A Status:N/A Attempts:0
Profile:N/A Convergence Time: 00:00:00
Rate-Selection:Disabled Locking:Not-Configured
Downstream Margin:0 Upstream Margin:0
<output truncated>
This is an example of output from the show controllers lre status cpe command:
Switch# show controllers lre status cpe
Lo0/1 : CPE-TYPE:Cisco575-LRE
Port Status Speed Duplex Protected
---- ------------ ----- ------ ---------
1 notconnected NA NA false
Lo0/2 : CPE-TYPE:NA
Port Status Speed Duplex Protected
---- ------------ ----- ------ ---------
1 NA NA NA NA
Lo0/3 : CPE-TYPE:CISCO585-LRE
Port Status Speed Duplex Protected
---- ------------ ----- ------ ---------
1 notconnected auto NA false
2 notconnected auto NA true
3 notconnected auto NA false
4 notconnected auto NA false
5 connected 100 half false