Cisco Catalyst 2950 - Page 681

Index
IN-11
Catalyst 2950 and Catalyst 2955 Switch Command Reference
78-11381-12
queues
CoS-to-egress-queue map
2-563
expedite 2-561
WRR weights 2-561
trusted boundary for Cisco SoftPhones 2-218
trusted boundary for IP phones 2-218
quality of service
See QoS
querytime, MVR
2-224
R
rapid per-VLAN spanning-tree plus
See STP
rapid PVST+
See STP
rate selection, resetting
2-46
rate selection command 2-252
rate selection profile lock command 2-253
rate selection sequence command 2-255
rcommand command 2-257
re-authenticating 802.1x-enabled ports 2-104
re-authentication
periodic
2-106
time between attempts 2-107
receiver port, MVR 2-228
receiving flow-control packets 2-115
recovery mechanism
causes
2-113
displaying 2-327
timer interval 2-113
redundancy for cluster switches 2-66
relay-major command A-6
relay-minor command A-6
remote-span command 2-259
Remote Switched Port Analyzer
See RSPAN
rename command
B-18
reset command 2-544, B-19
reset interface 2-41
reset LRE rate selection setting 2-46
restricted VLAN
See dot1x auth-fail VLAN
rmdir command
B-20
rmon collection stats command 2-261
root guard, for spanning tree 2-452
RPS status display 2-398
RSPAN
and IDS
2-223
configuring 2-221
displaying 2-382
remote-span command 2-259
sessions
adding interfaces to
2-221
displaying 2-382
starting new 2-221
S
secondary temperature alarm A-4
sending flow-control packets 2-115
service password-recovery command 2-263
service-policy command 2-265
set command 2-266
set command, bootloader B-21
setup express command 2-268
SFP 2-211
SFP module preferred 2-211
show access-lists command 2-270
show alarm description port command A-11
show alarm profile command A-12
show alarm settings command A-14
show auto qos command 2-272
show boot command 2-275
show changes command 2-544
show class-map command 2-277
show cluster candidates command 2-282
show cluster command 2-279