Cisco Catalyst 3550

2-78
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
dot1x
Examples This example shows how to enable IEEE 802.1x authentication globally on a switch:
Switch(config)# dot1x system-auth-control
You can verify your settings by entering the show dot1x privileged EXEC command.
Related Commands Command Description
dot1x guest-vlan Enables and specifies an active VLAN as an IEEE 802.1x guest VLAN.
dot1x port-control Enables manual control of the authorization state of the port.
show dot1x Displays IEEE 802.1x statistics, administrative status, and operational status
for the switch or for the specified interface.