Cisco Catalyst 3550

2-601
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-01
Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
switchport unicast
switchport unicast
This is an obsolete command.
In past releases, the switchport unicast interface configuration command was used to set the multicast
suppression level on the interface. This command is replaced by the storm-control unicast interface
configuration command.
Command History
Related Commands
Release Modification
12.1(4)EA1 This command was introduced.
12.1(8)EA1 This command was replaced by the storm-control command.
Command Description
show storm-control unicast Displays unicast suppression settings on an interface or on all
interfaces.
storm-control Sets broadcast, multicast, or unicast storm control on an interface with
the specified threshold level.
switchport broadcast Obsolete command. Replaced by the storm-control broadcast
interface configuration command.
switchport multicast Obsolete command. Replaced by the storm-control multicast
interface configuration command.