Cisco Catalyst 3550

B-23
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Appendix B Catalyst 3550 Switch Debug Commands
debug l3tcam
debug l3tcam
Use the debug l3tcam privileged EXEC command to enable debugging of the Layer 3 ternary content
addressable memory (TCAM) manager software module. This module controls the allocation of the part
of the TCAM used in IP unicast and multicast routing, including the allocation of both routes and
adjacencies in the TCAM. Use the no form of this command to disable debugging.
debug l3tcam
no debug l3tcam
Syntax Description This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug l3tcam command is the same as the no debug l3tcam command.
Related Commands
Release Modification
12.1(4)EA1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.