2-452
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-01
Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
show mvr members
show mvr members
Use the show mvr members privileged EXEC command to display all receiver and source ports that are
currently members of an IP multicast group.
show mvr members [ip-address] [ | {begin | exclude | include} expression]
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines The show mvr members command applies to receiver and source ports. For MVR compatible mode, all
source ports are members of all multicast groups.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show mvr members command:
Switch# show mvr members
MVR Group IP Status Members
------------ ------ -------
239.255.0.1 ACTIVE Gi0/1(d), Gi0/5(s)
239.255.0.2 INACTIVE None
239.255.0.3 INACTIVE None
239.255.0.4 INACTIVE None
239.255.0.5 INACTIVE None
239.255.0.6 INACTIVE None
239.255.0.7 INACTIVE None
239.255.0.8 INACTIVE None
239.255.0.9 INACTIVE None
239.255.0.10 INACTIVE None
<output truncated>
239.255.0.255 INACTIVE None
239.255.1.0 INACTIVE None
ip-address (Optional) The IP multicast address. If the address is entered, all receiver and
source ports that are members of the multicast group appear. If no address is
entered, all members of all Multicast VLAN Registration (MVR) groups are
listed. If a group has no members, the group is listed as Inactive.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.1(4)EA1 This command was introduced.
To Next Page
Loading...
Need help?
General
