2-64
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
cluster outside-interface
cluster outside-interface
Use the cluster outside-interface global configuration command to configure the outside interface for
cluster Network Address Translation (NAT) so that a member without an IP address can communicate
with devices outside the cluster. Use the no form of this command to return to the default setting.
cluster outside-interface interface-id
no cluster outside-interface
Syntax Description
Defaults The default outside interface is automatically selected by the command switch.
Command Modes Global configuration
Command History
Usage Guidelines Enter this command only on the command switch. If you enter this command on a member switch, an
error message appears.
Examples This example shows how to set the outside interface to VLAN 1:
Switch(config)# cluster outside-interface vlan 1
You can verify your setting by entering the show running-config privileged EXEC command.
Related Commands
interface-id Interface to serve as the outside interface. Valid interfaces include
physical interfaces, port-channels, or VLANs. The port-channel
range is 1 to 64. The VLAN range is 1 to 4094.
Release Modification
12.1(4)EA1 This command was introduced.
Command Description
show running-config Displays the current operating configuration. For syntax information,
select Cisco IOS Release 12.2 Configuration Guides and Command
References > Cisco IOS Configuration Fundamentals Command
Reference, Release 12.2 > File Management Commands >
Configuration File Management Commands.
To Next Page
Loading...
Need help?
General
