Cisco Catalyst 3550

2-404
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-01
Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
show ip source binding
show ip source binding
Use the show ip source binding user EXEC command to display the IP source bindings on the switch.
show ip source binding [ip-address] [mac-address] [dhcp-snooping | static] [interface
interface-id] [vlan vlan-id] [ | {begin | exclude | include} expression]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines The show ip source binding command output shows the dynamically and statically configured bindings
in the Dynamic Host Configuration Protocol (DHCP) snooping binding database. Use the show ip dhcp
snooping binding privileged EXEC command to display only the dynamically configured bindings.
Examples This is an example of output from the show ip source binding command:
Switch> show ip source binding
MacAddress IpAddress Lease(sec) Type VLAN Interface
-------------- --------------- ---------- ------------- ---- --------------------
00:00:00:0A:00:0B 11.0.0.1 infinite static 10 GigabitEthernet0/1
00:00:00:0A:00:0A 11.0.0.2 10000 dhcp-snooping 10 GigabitEthernet0/1
Related Commands
ip-address (Optional) Display IP source bindings for a specific IP address.
mac-address (Optional) Display IP source bindings for a specific MAC address.
dhcp-snooping (Optional) Display IP source bindings that were learned by DHCP
snooping.
static (Optional) Display static IP source bindings.
interface interface-id (Optional) Display IP source bindings on a specific interface.
vlan vlan-id (Optional) Display IP source bindings on a specific VLAN.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(25)SEA This command was introduced.
Command Description
ip dhcp snooping binding Configures the DHCP snooping binding database.
ip source binding Configures static IP source bindings on the switch.