Cisco Catalyst 3550 User Manual

2-14
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
archive tar
Defaults None
Command Modes Privileged EXEC
Command History
Usage Guidelines Filenames and directory names are case sensitive.
Image names are case sensitive.
/table source-url Display the contents of an existing tar file to the screen.
For source-url, specify the source URL alias for the local or network file
system. These options are supported:
• The syntax for the local flash file system:
flash:
• The syntax for the FTP:
ftp:[[//username[:password]@location]/directory]/tar-filename.tar
• The syntax for the Remote Copy Protocol (RCP):
rcp:[[//username@location]/directory]/tar-filename.tar
• The syntax for the TFTP:
tftp:[[//location]/directory]/tar-filename.tar
The tar-filename.tar is the tar file to display.
/xtract source-url
flash:/file-url [dir/file...]
Extract files from a tar file to the local file system.
For source-url, specify the source URL alias for the local or network file
system. These options are supported:
• The syntax for the local flash file system:
flash:
• The syntax for the FTP:
ftp:[[//username[:password]@location]/directory]/tar-filename.tar
• The syntax for the Remote Copy Protocol (RCP):
rcp:[[//username@location]/directory]/tar-filename.tar
• The syntax for the TFTP:
tftp:[[//location]/directory]/tar-filename.tar
The tar-filename.tar is the tar file from which to extract.
For flash:/file-url, specify the location on the local flash file system into
which the tar file is extracted.
For flash:/file-url [dir/file...], specify the location on the local flash file
system into which the tar file is extracted. Use the dir/file... option to
specify an optional list of files or directories within the tar file to be
extracted. If none are specified, all files and directories are extracted.
Release Modification
12.1(4)EA1 This command was introduced.

Cisco Catalyst 3550 Specifications

General

Category	Switch
QoS	Yes
Form Factor	Rack-mountable
Manageable	Yes
RAM	64 MB
Model	Catalyst 3550
Uplink Ports	2 x GBIC (Gigabit Interface Converter) or SFP (Small Form-factor Pluggable)
Layer Support	Layer 3
VLAN Support	Yes
MAC Address Table Size	12000 entries
Routing Protocol	EIGRP
Features	QoS
Operating Temperature	32 to 113°F (0 to 45°C)
Operating Humidity	10 - 95% (non-condensing)
Ports	24 or 48 10/100 ports