Cisco Catalyst 3550

B-16
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Appendix B Catalyst 3550 Switch Debug Commands
debug ilpower controller
debug ilpower controller
Use the debug ilpower controller privileged EXEC command to enable debugging of the
platform-specific Power over Ethernet (PoE) software module on the Catalyst 3550-24PWR switch in
long message format. These messages include the Power Controller register reading. Use the no form of
this command to disable debugging.
debug ilpower controller
no debug ilpower controller
Syntax Description This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug ilpower controller command is the same as the no debug ilpower controller.
Related Commands
Release Modification
12.1(12c)EA1 This command was introduced.
Command Description
debug ilpower event Enables debugging of the platform-specific PoE software module in a
short message format.