Cisco Catalyst 3550

2-464
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-01
Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
show power inline
show power inline
Use the show power inline user EXEC command to display the power status for the specified Power
over Ethernet (PoE) port or for all PoE ports on the Catalyst 3550-24PWR switch.
show power inline [interface-id] | {begin | exclude | include} expression]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines This command is supported only on PoE-capable ports. PoE ports were previously referred to as inline
power ports in earlier versions of the command reference.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show power inline command:
Switch> show power inline
Interface Admin Oper Power Device Class Max
(Watts)
--------- ------ ---------- ------- ------------------- ----- ----
Fa0/1 auto off 0.0 n/a n/a 15.4
Fa0/2 auto off 0.0 n/a n/a 15.4
Fa0/3 auto on 5.4 Cisco IP phone 7960 n/a 15.4
Fa0/4 auto on 15.4 Ieee PD 15.4
Fa0/5 auto off 0.0 n/a n/a 15.4
Fa0/6 auto off 0.0 n/a n/a 15.4
Fa0/7 auto off 0.0 n/a n/a 15.4
Fa0/8 auto off 0.0 n/a n/a 15.4
Fa0/9 auto off 0.0 n/a n/a 15.4
Fa0/10 auto off 0.0 n/a n/a 15.4
<output truncated>
interface-id (Optional) ID of the interface.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.1(12c)EA1 This command was introduced.
12.1(19)EA1 The Class field was added to the output.
12.2(25)SE The Max field was added to the output.