Cisco Catalyst 3550

B-17
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Appendix B Catalyst 3550 Switch Debug Commands
debug ilpower event
debug ilpower event
Use the debug ilpower event privileged EXEC command to enable debugging of the platform-specific
Power over Ethernet (PoE) software module on the Catalyst 3550-24PWR switch in a short message
format. These messages display the PoE state and events received. Use the no form of this command to
disable debugging.
debug ilpower event
no debug ilpower event
Syntax Description This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug ilpower event command is the same as the no debug ilpower event.
Related Commands
Release Modification
12.1(12c)EA1 This command was introduced.
Command Description
debug ilpower controller Enables debugging of the platform-specific PoE software module in
long message format.