Cisco Catalyst 3550

2-424
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-01
Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
show mac address-table count
show mac address-table count
Use the show mac address-table count user EXEC command to display the number of addresses
present in all VLANs or the specified VLAN.
show mac address-table count [vlan vlan-id] [ | {begin | exclude | include} expression]
Note Beginning with Cisco IOS Release 12.1(11)EA1, the show mac address-table count command replaces
the show mac-address-table count command (with the hyphen).
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines If no VLAN number is specified, the address count for all VLANs appears.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show mac address-table count command:
Switch> show mac address-table count
Mac Entries for Vlan : 1
---------------------------
Dynamic Address Count : 2
Static Address Count : 0
Total Mac Addresses : 2
vlan vlan-id (Optional) Display the number of addresses for a specific VLAN. The range is 1 to
4094.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.1(4)EA1 This command was introduced.
12.1(11)EA1 The show mac-address-table count command was replaced by the show
mac address-table count command.