Cisco Catalyst 3550

B-27
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Appendix B Catalyst 3550 Switch Debug Commands
debug met
debug met
Use the debug met privileged EXEC command to enable debugging of the allocation, freeing, and
updating of the multicast expansion table (MET) entries. These entries are used by the hardware when
forwarding individual IP multicast and fallback-bridged packets to multiple output VLANs. Use the no
form of this command to disable debugging.
debug met
no debug met
Syntax Description This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug met command is the same as the no debug met command.
Related Commands
Release Modification
12.1(4)EA1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.