EasyManuals Logo

Cisco Catalyst 3550 User Manual

Cisco Catalyst 3550
794 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #172 background imageLoading...
Page #172 background image
2-146
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
ip arp inspection vlan logging
ip arp inspection vlan logging
Use the ip arp inspection vlan logging global configuration command to control the type of packets
that are logged per VLAN. Use the no form of this command to disable this logging control.
ip arp inspection vlan vlan-range logging {acl-match {matchlog | none} | dhcp-bindings {all |
none | permit}}
no ip arp inspection vlan vlan-range logging {acl-match | dhcp-bindings}
Syntax Description
Defaults All denied or all dropped packets are logged.
Command Modes Global configuration
Command History
Usage Guidelines The term logged means that the entry is placed into the log buffer and that a system message is generated.
vlan-range Specify the VLANs configured for logging.
You can specify a single VLAN identified by VLAN ID number, a range of
VLANs separated by a hyphen, or a series of VLANs separated by a comma.
The range is 1 to 4094.
acl-match {matchlog |
none}
Specify that the logging of packets is based on access control list (ACL)
matches.
The keywords have these meanings:
matchlog—Log packets based on the logging configuration specified in
the access control entries (ACE). If you specify the matchlog keyword in
this command and the log keyword in the permit or deny ARP access-list
configuration command, Address Resolution Protocol (ARP) packets
permitted or denied by the ACL are logged.
none—Do not log packets that match ACLs.
dhcp-bindings
{permit | all | none}
Specify the logging of packets is based on Dynamic Host Configuration
Protocol (DHCP) binding matches.
The keywords have these meanings:
all—Log all packets that match DHCP bindings.
none—Do not log packets that match DHCP bindings.
permit—Log DHCP-binding permitted packets.
Release Modification
12.2(25)SEA This command was introduced.

Table of Contents

Other manuals for Cisco Catalyst 3550

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3550 and is the answer not in the manual?

Cisco Catalyst 3550 Specifications

General IconGeneral
CategorySwitch
QoSYes
Form FactorRack-mountable
ManageableYes
RAM64 MB
ModelCatalyst 3550
Uplink Ports2 x GBIC (Gigabit Interface Converter) or SFP (Small Form-factor Pluggable)
Layer SupportLayer 3
VLAN SupportYes
MAC Address Table Size12000 entries
Routing ProtocolEIGRP
FeaturesQoS
Operating Temperature32 to 113°F (0 to 45°C)
Operating Humidity10 - 95% (non-condensing)
Ports24 or 48 10/100 ports

Related product manuals