Cisco Catalyst 3550

2-314
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-01
Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
show access-lists
show access-lists
Use the show access-lists privileged EXEC command to display access control lists (ACLs) configured
on the switch.
show access-lists [name | number | hardware counters] [ | {begin | exclude | include} expression]
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines The switch supports only IP standard and extended access lists. Therefore, the allowed numbers are only
1 to 199 and 1300 to 2699.
This command also displays the MAC ACLs that are configured.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show access-lists command:
Switch# show access-lists
Standard IP access list 13
10 permit any
Standard IP access list permit Any
10 permit any
Extended IP access list 101
10 permit icmp any any conversion-error
20 permit 234 host 172.30.40.1 host 123.23.23.2
Extended IP access list 102
10 permit esp any any
20 permit eigrp any any tos min-monetary-cost
Extended IP access list 103
10 permit icmp any any 40 60
Extended IP access list CMP-NAT-ACL
10 Dynamic Cluster-NAT permit ip any any
Extended MAC access list abc2
name (Optional) Name of the ACL.
number (Optional) ACL number. The range is from 1 to 2699.
hardware counters (Optional) Display global hardware ACL statistics for switched and
routed packets.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.1(4)EA1 This command was introduced.