Cisco Catalyst 3550

B-2
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Appendix B Catalyst 3550 Switch Debug Commands
debug acltcam
debug acltcam
Use the debug acltcam privileged EXEC command to enable debugging of the actions of the quality of
service/access control list (QoS/ACL) ternary content addressable memory (TCAM) manager software
module. This module controls the allocation and updating of entries in the parts of the TCAM used for
input security ACLs, output security ACLs, and QoS ACLs. Use the no form of this command to disable
debugging.
debug acltcam [verbose]
no debug acltcam [verbose]
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug acltcam command is the same as the no debug acltcam command.
Related Commands
verbose (Optional) Display detailed debug messages.
Release Modification
12.1(4)EA1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.