2-379
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-01
Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
show interfaces counters
show interfaces counters
Use the show interfaces counters privileged EXEC command to display various counters for the switch
or for a specific interface.
show interfaces [interface-id] counters [errors | etherchannel | protocol status | trunk] [ | {begin
| exclude | include} expression]
Syntax Description
Note Though visible in the command-line help strings, the module and vlan-id keywords are not supported.
Command Modes Privileged EXEC
Command History
Usage Guidelines If you do not enter any keywords, all counters for all interfaces are included.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show interfaces counters command. It displays all counters for
the switch.
Switch# show interfaces counters
Port InOctets InUcastPkts InMcastPkts InBcastPkts
Gi0/1 23324617 10376 185709 126020
Gi0/2 0 0 0 0
Port OutOctets OutUcastPkts OutMcastPkts OutBcastPkts
interface-id (Optional) ID of the physical interface, including type and slot and port
number.
errors (Optional) Display error counters.
etherchannel (Optional) Display EtherChannel counters.
protocol status (Optional) Display the current status of enabled protocols.
trunk (Optional) Display trunk counters.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.1(4)EA1 This command was introduced.
12.2(25)SE The etherchannel and protocol status keywords were added and the
broadcast, multicast, and unicast keywords were removed.
To Next Page
Loading...
