Cisco Catalyst 3550

2-131
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
ip admission
ip admission
Use the ip admission interface configuration command to enable web authentication. You can also use
this command in fallback-profile mode. Use the no form of this command to disable web authentication.
ip admission rule
no ip admission
Syntax Description
Command Modes Global configuration
Command History
Usage Guidelines The ip admission command applies a web authentication rule to a switch port.
Examples This example shows how to apply a web authentication rule to a switchport:
Switch# configure terminal
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# ip admission rule1
This example shows how to apply a web authentication rule to a fallback profile for use on an
IEEE
802.1x enabled switch port.
Switch# configure terminal
Switch(config)# fallback profile profile1
Switch(config)# ip admission name rule1
Switch(config)# end
Related Commands
Command Description
show running-config Displays the running configuration on the switch. For syntax information,
select Cisco IOS Release 12.2 Configuration Guides and Command
References > Cisco IOS Configuration Fundamentals Command
Reference, Release 12.2 > File Management Commands >
Configuration File Management Commands.
rule Apply an IP admission rule to the interface.
Release Modification
12.2(35)SE This command was introduced.
Command Description
dot1x fallback Configure a port to use web authentication as a fallback method for clients
that do not support IEEE
802.1x authentication.
fallback profile Enable web authentication on a port