B-31
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Appendix B Catalyst 3550 Switch Debug Commands
debug platform ip arp inspection
debug platform ip arp inspection
Use the debug platform ip arp inspection privileged EXEC command to debug dynamic Address
Resolution Protocol (ARP) inspection events. Use the no form of this command to disable debugging.
debug platform ip arp inspection {all | error | event | packet | rpc}
no debug platform ip arp inspection {all | error | event | packet | rpc}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform ip arp inspection command is the same as the no debug platform ip arp
inspection command.
Related Commands
all Display all dynamic ARP inspection debug messages.
error Display dynamic ARP inspection error debug messages.
event Display dynamic ARP inspection event debug messages.
packet Display dynamic ARP inspection packet-related debug messages.
rpc Display dynamic ARP inspection remote procedure call (RPC) request debug
messages.
Release Modification
12.2(25)SEA This command was introduced.
Command Description
show ip arp inspection Displays the dynamic ARP inspection configuration and operating state.
show debugging Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
To Next Page
Loading...
Need help?
General
