Cisco Catalyst 3550

2-168
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
ip igmp filter
ip igmp filter
Use the ip igmp filter interface configuration command to control whether or not all hosts on a Layer 2
interface can join one or more IP multicast groups by applying an Internet Group Management Protocol
(IGMP) profile to the interface. Use the no form of this command to remove the specified profile from
the interface.
ip igmp filter profile number
no ip igmp filter
Syntax Description
Defaults No IGMP filters are applied.
Command Modes Interface configuration
Command History
Usage Guidelines You can apply IGMP filters only to Layer 2 physical interfaces; you cannot apply IGMP filters to routed
ports, switch virtual interfaces (SVIs), or ports that belong to an EtherChannel group.
An IGMP profile can be applied to one or more switch port interfaces, but one port can have only one
profile applied to it.
Examples This example shows how to apply IGMP profile 22 to an interface.
Switch(config)# interface fastethernet0/1
Switch(config-if)# ip igmp filter 22
You can verify your setting by using the show running-config privileged EXEC command and by
specifying an interface.
Switch# show running-config interface fastethernet0/1
Building configuration...
Current configuration : 124 bytes
!
interface FastEthernet0/1
no ip address
shutdown
snmp trap link-status
ip igmp filter 22
end
profile number The IGMP profile number to be applied. The range is 1 to 4294967295.
Release Modification
12.1(8)EA1 This command was introduced.