Cisco Catalyst 3550

B-13
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Appendix B Catalyst 3550 Switch Debug Commands
debug ethernet-controller ram-access
debug ethernet-controller ram-access
Use the debug ethernet-controller ram-access privileged EXEC command to enable debugging of the
driver that controls reads from and writes to the private (not directly accessible by the CPU) RAM
connected to the forwarding application-specific integrated circuits (ASICs). Use the no form of this
command to disable debugging.
debug ethernet-controller ram-access
no debug ethernet-controller ram-access
Syntax Description This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug ethernet-controller ram-access command is the same as the no debug
ethernet-controller ram-access command.
Related Commands
Release Modification
12.1(4)EA1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.