Cisco Catalyst 3550

2-580
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-01
Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
switchport broadcast
switchport broadcast
This is an obsolete command.
In past releases, the switchport broadcast interface configuration command was used to set the
broadcast suppression level on the interface. This command is replaced by the storm-control broadcast
interface configuration command.
Command History
Related Commands
Release Modification
12.1(4)EA1 This command was introduced.
12.1(8)EA1 This command was replaced by the storm-control command.
Command Description
show storm-control broadcast Displays broadcast suppression settings on an interface or on all
interfaces.
storm-control Sets broadcast, multicast, or unicast storm control on an interface
with the specified threshold level.
switchport multicast Obsolete command. Replaced by the storm-control multicast
interface configuration command.
switchport unicast Obsolete command. Replaced by the storm-control unicast
interface configuration command.