Cisco Catalyst 3550

B-25
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Appendix B Catalyst 3550 Switch Debug Commands
debug mac-manager
debug mac-manager
Use the debug mac-manager privileged EXEC command to enable debugging of the platform-specific
MAC address table manager software module. This command debugs the platform-specific part of
learning MAC addresses on VLANs and updating the hardware with the necessary information. Use the
no form of this command to disable debugging.
debug mac-manager
no debug mac-manager
Syntax Description This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug mac-manager command is the same as the no debug mac-manager command.
Related Commands
Release Modification
12.1(4)EA1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.