Cisco Catalyst 3550

2-7
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
access-list hardware program nonblocking
Related Commands Command Description
access-list {deny | permit} Configures a standard numbered ACL. For syntax information, select
Cisco IOS Release 12.2 Configuration Guides and Command
References > Cisco IOS IP Command Reference, Volume 1 of 3:
Addressing and Services, Release 12.2 > IP Services Commands.
action (access map
configuration)
Defines or modifies the action for the VLAN access map entry.
ip access-group Applies an IP access list to a Layer 2 or Layer 3 interface.
ip access-list Configures a named access list. For syntax information, select Cisco
IOS Release 12.2 Configuration Guides and Command References >
Cisco IOS IP Command Reference, Volume 1 of 3: Addressing
and Services, Release 12.2 > IP Services Commands.
mac access-group Applies a MAC access list to a Layer 2 interface.
match (access-map
configuration)
Defines the match conditions for a VLAN map.
show running-config | include
access-list hardware
Displays the current operating configuration. For syntax information,
select Cisco IOS Release 12.2 Configuration Guides and
Command References > Cisco IOS Configuration Fundamentals
Command Reference, Release 12.2 > File Management
Commands > Configuration File Management Commands.
vlan access-map Creates a VLAN access map or enters access-map configuration
mode.
vlan filter Applies a VLAN map to one or more VLANs.