EasyManuals Logo

Cisco Catalyst 3550 User Manual

Cisco Catalyst 3550
794 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #565 background imageLoading...
Page #565 background image
2-539
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-01
Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
spanning-tree mst cost
spanning-tree mst cost
Use the spanning-tree mst cost interface configuration command to set the path cost for multiple
spanning-tree (MST) calculations. If a loop occurs, spanning tree considers the path cost when selecting
an interface to put in the forwarding state. Use the no form of this command to return to the default
setting.
spanning-tree mst instance-id cost cost
no spanning-tree mst instance-id cost
Syntax Description
Defaults The default path cost is computed from the interface bandwidth setting. These are the IEEE default path
cost values:
1000 Mbps—20000
100 Mbps—200000
10 Mbps—2000000
Command Modes Interface configuration
Command History
Usage Guidelines When you configure the cost, higher values represent higher costs.
Examples This example shows how to set a path cost of 250 on an interface associated with instances 2 and 4:
Switch(config)# interface fastethernet0/1
Switch(config-if)# spanning-tree mst 2,4 cost 250
You can verify your settings by entering the show spanning-tree mst interface interface-id privileged
EXEC command.
instance-id Range of spanning-tree instances. You can specify a single instance, a range of
instances separated by a hyphen, or a series of instances separated by a comma. The
range is 0 to 4094.
cost Path cost is 1 to 200000000, with higher values meaning higher costs.
Release Modification
12.1(9)EA1 This command was introduced.
12.1(13)EA1 The value for the instance-id variable was changed.
12.2(25)SEC The instance-id range changed to1 to 4094.

Table of Contents

Other manuals for Cisco Catalyst 3550

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3550 and is the answer not in the manual?

Cisco Catalyst 3550 Specifications

General IconGeneral
CategorySwitch
QoSYes
Form FactorRack-mountable
ManageableYes
RAM64 MB
ModelCatalyst 3550
Uplink Ports2 x GBIC (Gigabit Interface Converter) or SFP (Small Form-factor Pluggable)
Layer SupportLayer 3
VLAN SupportYes
MAC Address Table Size12000 entries
Routing ProtocolEIGRP
FeaturesQoS
Operating Temperature32 to 113°F (0 to 45°C)
Operating Humidity10 - 95% (non-condensing)
Ports24 or 48 10/100 ports

Related product manuals