Cisco Catalyst 3550 User Manual

2-451
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-01
Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
show mvr interface
• Inactive means that the port is not yet part of any VLAN.
This is an example of output from the show mvr interface gigabitethernet0/2 command:
Switch# show mvr interface gigabitethernet0/2
Type: RECEIVER Status: ACTIVE Immediate Leave: DISABLED
This is an example of output from the show mvr interface gigabitethernet0/1 members command:
Switch# show mvr interface gigabitethernet0/1 members
239.255.0.0 DYNAMIC ACTIVE
239.255.0.1 DYNAMIC ACTIVE
239.255.0.2 DYNAMIC ACTIVE
239.255.0.3 DYNAMIC ACTIVE
239.255.0.4 DYNAMIC ACTIVE
239.255.0.5 DYNAMIC ACTIVE
239.255.0.6 DYNAMIC ACTIVE
239.255.0.7 DYNAMIC ACTIVE
239.255.0.8 DYNAMIC ACTIVE
239.255.0.9 DYNAMIC ACTIVE
Related Commands Command Description
mvr (global configuration) Enables and configures multicast VLAN registration on the
switch.
mvr (interface configuration) Configures MVR ports.
show mvr Displays the global MVR configuration on the switch.
show mvr members Displays all receiver ports that are members of an MVR
multicast group.

Cisco Catalyst 3550 Specifications

General

Category	Switch
QoS	Yes
Form Factor	Rack-mountable
Manageable	Yes
RAM	64 MB
Model	Catalyst 3550
Uplink Ports	2 x GBIC (Gigabit Interface Converter) or SFP (Small Form-factor Pluggable)
Layer Support	Layer 3
VLAN Support	Yes
MAC Address Table Size	12000 entries
Routing Protocol	EIGRP
Features	QoS
Operating Temperature	32 to 113°F (0 to 45°C)
Operating Humidity	10 - 95% (non-condensing)
Ports	24 or 48 10/100 ports