Cisco Catalyst 3550

B-14
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Appendix B Catalyst 3550 Switch Debug Commands
debug fallback-bridging
debug fallback-bridging
Use the debug fallback-bridging privileged EXEC command to enable debugging of the fallback
bridging manager software module. This command debugs the platform-specific part of the process of
learning MAC addresses on bridge groups and updating the hardware with the necessary information.
Use the no form of this command to disable debugging.
debug fallback-bridging
no debug fallback-bridging
Syntax Description This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug fallback-bridging command is the same as the no debug fallback-bridging command.
Related Commands
Release Modification
12.1(4)EA1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.