EasyManuals Logo

Cisco Catalyst 3550 User Manual

Cisco Catalyst 3550
794 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #552 background imageLoading...
Page #552 background image
2-526
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-01
Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
spanning-tree etherchannel guard misconfig
spanning-tree etherchannel guard misconfig
Use the spanning-tree etherchannel guard misconfig global configuration command to display an
error message when the switch detects a loop that occurred because of an EtherChannel
misconfiguration. Use the no form of this command to disable the feature.
spanning-tree etherchannel guard misconfig
no spanning-tree etherchannel guard misconfig
Syntax Description This command has no arguments or keywords.
Defaults EtherChannel guard is enabled on the switch.
Command Modes Global configuration
Command History
Usage Guidelines When the switch detects a loop that is caused by an EtherChannel misconfiguration, this error message
appears:
PM-4-ERR_DISABLE: Channel-misconfig error detected on [chars], putting [chars] in
err-disable state.
To determine which switch ports are in EtherChannel misconfiguration, use the show interfaces status
err-disabled privileged EXEC command. To verify the EtherChannel configuration on a remote device,
use the show etherchannel summary privileged EXEC command on the remote device.
When a port is in the error-disabled state because of an EtherChannel misconfiguration, you can bring
it out of this state by entering the errdisable recovery cause channel-misconfig global configuration
command, or you can manually re-enable it by entering the shutdown and no shut down interface
configuration commands.
Examples This example shows how to enable the EtherChannel guard feature:
Switch(config)# spanning-tree etherchannel guard misconfig
You can verify your settings by entering the show spanning-tree summary privileged EXEC command.
Release Modification
12.1(13)EA1 This command was introduced.

Table of Contents

Other manuals for Cisco Catalyst 3550

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3550 and is the answer not in the manual?

Cisco Catalyst 3550 Specifications

General IconGeneral
CategorySwitch
QoSYes
Form FactorRack-mountable
ManageableYes
RAM64 MB
ModelCatalyst 3550
Uplink Ports2 x GBIC (Gigabit Interface Converter) or SFP (Small Form-factor Pluggable)
Layer SupportLayer 3
VLAN SupportYes
MAC Address Table Size12000 entries
Routing ProtocolEIGRP
FeaturesQoS
Operating Temperature32 to 113°F (0 to 45°C)
Operating Humidity10 - 95% (non-condensing)
Ports24 or 48 10/100 ports

Related product manuals