Cisco Catalyst 3550 User Manual

A-18
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Appendix A Catalyst 3550 Switch Boot Loader Commands
reset
reset
Use the reset boot loader command to perform a hard reset on the system. A hard reset is similar to
power-cycling the switch, clearing the processor, registers, and memory.
reset
Syntax Description This command has no arguments or keywords.
Command Modes Boot loader
Command History
Examples This example shows how to reset the system:
switch: reset
Are you sure you want to reset the system (y/n)?y
System resetting...
Related Commands
Release Modification
12.1(4)EA1 This command was introduced.
Command Description
boot Loads and boots an executable image and enters the command-line interface.

Cisco Catalyst 3550 Specifications

General

Category	Switch
QoS	Yes
Form Factor	Rack-mountable
Manageable	Yes
RAM	64 MB
Model	Catalyst 3550
Uplink Ports	2 x GBIC (Gigabit Interface Converter) or SFP (Small Form-factor Pluggable)
Layer Support	Layer 3
VLAN Support	Yes
MAC Address Table Size	12000 entries
Routing Protocol	EIGRP
Features	QoS
Operating Temperature	32 to 113°F (0 to 45°C)
Operating Humidity	10 - 95% (non-condensing)
Ports	24 or 48 10/100 ports