EasyManuals Logo

Cisco Catalyst 3550 User Manual

Cisco Catalyst 3550
794 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
1-5
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Chapter 1 Using the Command-Line Interface
CLI Command Modes
Enter the vlan database privileged EXEC command to access VLAN configuration mode:
Switch# vlan database
Switch(vlan)#
The supported commands can vary depending on the version of software in use. To view a
comprehensive list of commands, enter a question mark (?) at the prompt:
Switch(vlan)# ?
To return to privileged EXEC mode, enter the abort VLAN configuration command to abandon the
proposed database. Otherwise, enter exit to implement the proposed new VLAN database and to return
to privileged EXEC mode. When you enter exit or apply, the configuration is saved in the VLAN
database; configuration from VLAN configuration mode cannot be saved in the switch configuration
file.
Line Configuration Mode
Line configuration commands modify the operation of a terminal line. Line configuration commands
always follow a line command, which defines a line number. Use these commands to change terminal
parameter settings line-by-line or for a range of lines.
Use the line vty line_number [ending_line_number] command to enter line configuration mode. The
new prompt means line configuration mode. The following example shows how to enter line
configuration mode for virtual terminal line
7:
Switch(config)# line vty 0 7
The supported commands can vary depending on the version of software in use. To view a
comprehensive list of commands, enter a question mark (?) at the prompt:
Switch(config-line)# ?
To exit line configuration mode and to return to global configuration mode, use the exit command. To
exit line configuration mode and to return to privileged EXEC mode, enter the end command, or press
Ctrl-Z.

Table of Contents

Other manuals for Cisco Catalyst 3550

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3550 and is the answer not in the manual?

Cisco Catalyst 3550 Specifications

General IconGeneral
CategorySwitch
QoSYes
Form FactorRack-mountable
ManageableYes
RAM64 MB
ModelCatalyst 3550
Uplink Ports2 x GBIC (Gigabit Interface Converter) or SFP (Small Form-factor Pluggable)
Layer SupportLayer 3
VLAN SupportYes
MAC Address Table Size12000 entries
Routing ProtocolEIGRP
FeaturesQoS
Operating Temperature32 to 113°F (0 to 45°C)
Operating Humidity10 - 95% (non-condensing)
Ports24 or 48 10/100 ports

Related product manuals