Cisco Catalyst 3550

B-11
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Appendix B Catalyst 3550 Switch Debug Commands
debug eap
debug eap
Use the debug eap privileged EXEC command to enable debugging of the Extensible Authentication
Protocol (EAP) activity. Use the no form of this command to disable debugging.
debug dot1x {all | authenticator | errors | events | md5 | packets | peer | sm}
no debug dot1x {all | authenticator | errors | events | md5 | packets | peer | sm}
Syntax Description
Command Default Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug dot1x command is the same as the no debug dot1x command.
Related Commands
all Display all EAP debug messages.
authenticator Display authenticator debug messages.
errors Display EAP error debug messages.
events Display EAP event debug messages.
md5 Display EAP-MD5 debug messages.
packets Display EAP packet debug messages.
peer Display EAP peer debug messages.
sm Display EAP state-machine related-events debug messages.
Release Modification
12.2(25)SEE This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled. For
syntax information, see the Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
show eap Displays EAP registration and session information for the switch or for the
specified port.