Cisco Catalyst 3550

B-30
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Appendix B Catalyst 3550 Switch Debug Commands
debug pbr
debug pbr
Use the debug pbr privileged EXEC command to enable debugging of policy-based routing (PBR)
events. Use the no form of this command to disable debugging.
debug pbr [acl-merge]
no debug pbr [acl-merge]
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug pbr command is the same as the no debug pbr command.
acl-merge (Optional) Display debug messages for the merge of ACLs present in a
route-map that are applied to an interface for PBR.
Release Modification
12.1(13)EA1 This command was introduced.