B-6
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Appendix B Catalyst 3550 Switch Debug Commands
debug cluster
debug cluster
Use the debug cluster privileged EXEC command to enable debugging of cluster-specific events. Use
the no form of this command to disable debugging.
debug cluster {discovery | events | extended | hsrp | http | ip [packet] | members | nat | neighbors
| snmp | vqpxy}
no debug cluster {discovery | events | extended | hsrp | http | ip [packet] | members | nat |
neighbors | snmp | vqpxy}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug cluster command is the same as the no debug cluster command.
Related Commands
discovery Display cluster discovery debug messages.
events Display cluster event debug messages.
extended Display extended discovery debug messages.
hsrp Display the Hot Standby Router Protocol (HSRP) debug messages.
http Display HTTP debug messages.
ip [packet] Display IP or transport packet debug messages.
members Display cluster member debug messages.
nat Display Network Address Translation (NAT) debug messages.
neighbors Display cluster neighbor debug messages.
snmp Display Simple Network Management Protocol (SNMP) debug messages.
vqpxy Display VLAN Query Protocol (VQP) proxy debug messages.
Release Modification
12.1(4)EA1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration
Guides and Command References > Cisco IOS Configuration
Fundamentals Configuration Guide, Release 12.2 > System
Management > Troubleshooting and Fault Management.
show cluster Displays the cluster status and a summary of the cluster to which the
switch belongs.
To Next Page
Loading...
Need help?
General
