Cisco Catalyst 3550

2-239
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
mls aclmerge delay
You can verify the ACL merge setting by entering the show running-config | include mls aclmerge
delay privileged EXEC command.
Related Commands Command Description
access-list { deny | permit} Configures a standard numbered ACL. For syntax information, select
Cisco IOS Release 12.2 Configuration Guides and Command
References > Cisco IOS IP Command Reference, Volume 1 of 3:
Addressing and Services, Release 12.2 > IP Services Commands.
action (access map
configuration)
Defines or modifies the action for the VLAN access map entry.
ip access-group Applies an IP access list to a Layer 2 or Layer 3 interface.
ip access-list Configures a named access list. For syntax information, select Cisco IOS
Release 12.2 Configuration Guides and Command References > Cisco
IOS IP Command Reference, Volume 1 of 3: Addressing and
Services, Release 12.2 > IP Services Commands.
mac access-group Applies a MAC access list to a Layer 2 interface.
match (access-map
configuration)
Defines the match conditions for a VLAN map.
show running-config |
include mls aclmerge
delay
Displays the current operating configuration. For syntax information,
select Cisco IOS Release 12.2 Configuration Guides and Command
References > Cisco IOS Configuration Fundamentals Command
Reference, Release 12.2 > File Management Commands >
Configuration File Management Commands.
vlan access-map Creates a VLAN access map or enters access-map configuration mode.
vlan filter Applies a VLAN map to one or more VLANs.