Cisco Catalyst 3550

2-306
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-01
Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
service-policy
Switch(config-if)# service-policy input plcmap1
This example shows how to apply plcmap2 to an egress interface:
Switch(config)# interface gigabitethernet0/2
Switch(config-if)# service-policy output plcmap2
This example shows how to detach plcmap2 from an interface:
Switch(config)# interface gigabitethernet0/2
Switch(config-if)# no service-policy input plcmap2
You can verify your settings by entering the show running-config privileged EXEC command.
Related Commands Command Description
policy-map Creates or modifies a policy map that can be attached to multiple interfaces
to specify a service policy.
show policy-map Displays quality of service (QoS) policy maps.