Cisco Catalyst 3550

Index
IN-3
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
clusters
adding candidates 2-62
binding to HSRP group 2-66
building manually 2-62
communicating with
devices outside the cluster 2-64
members by using Telnet 2-294
debug messages, display B-6
displaying
candidate switches 2-325
debug messages B-6
member switches 2-327
status 2-323
hop-count limit for extended discovery 2-59
HSRP standby groups 2-66
redundancy 2-66
SNMP trap 2-507
cluster standby-group command 2-66
cluster timer command 2-68
command modes defined 1-1
command switch
See clusters
configuration conflicts, ACL, displaying 2-360
configuration files
password recovery disable considerations A-1
setting the NVRAM size for 2-24
specifying the name 2-25, 2-30
configuring multiple interfaces 2-123
config-vlan mode
commands 2-620
description 1-4
entering 2-619
summary 1-2
copy (boot loader) command A-4
CoS
assigning default value to incoming packets 2-245
assigning to Layer 2 protocol packets 2-205
defining in a policy map 2-247
overriding the incoming value 2-245
CoS-to-DSCP map 2-251
CoS-to-egress-queue map 2-658
CPU ASIC
debug messages, display B-8
statistics display 2-329
CPU statistics, displaying 2-329
cross-stack UplinkFast, for STP 2-557
D
debug acltcam command B-2
debug auto qos command B-3
debug backup command B-5
debug cluster command B-6
debug cpu-interface command B-8
debug dot1x command B-9
debug eap command B-11
debug etherchannel command B-12
debug ethernet-controller ram-access command B-13
debug fallback-bridging command B-14
debug gigastack command B-15
debug ilpower controller command B-16
debug ilpower event command B-17
debug ip dhcp snooping command B-18
debug ip igmp filter command B-19
debug ip igmp max-groups command B-20
debug ip verify source packet command B-21
debug l3multicast command B-22
debug l3tcam command B-23
debug l3unicast command B-24
debug mac-manager command B-25
debug mac-notification command B-26
debug met command B-27
debug mvrdbg command B-28
debug pagp command B-29
debug pbr command B-30
debug platform ip arp inspection command B-31
debug pm command B-32
debug port-security command B-34