Cisco Catalyst 3550

2-67
Catalyst 3550 Multilayer Switch Command Reference
OL-8566-02
Chapter 2 Catalyst 3550 Switch Cisco IOS Commands
cluster standby-group
This example shows the error message when this command is executed on a command switch and the
specified HSRP standby group does not exist:
Switch(config)# cluster standby-group my_hsrp
%ERROR: Standby (my_hsrp) group does not exist
This example shows the error message when this command is executed on a member switch:
Switch(config)# cluster standby-group my_hsrp routing-redundancy
%ERROR: This command runs on a cluster command switch
You can verify your settings by entering the show cluster privileged EXEC command. The output shows
whether redundancy is enabled in the cluster.
Related Commands Command Description
standby ip Enables HSRP on the interface. For syntax information, select Cisco IOS
Release 12.2 Configuration Guides and Command References > Cisco IP
Command Reference, Volume 1 of 3: Addressing and Services, Release
12.2 > IP Services Commands.
show cluster Displays the cluster status and a summary of the cluster to which the switch
belongs.
show standby Displays standby group information. For syntax information, select Cisco
IOS Release 12.2 Configuration Guides and Command References > Cisco
IP Command Reference, Volume 1 of 3: Addressing and Services,
Release 12.2 > IP Services Commands.