Cisco Catalyst 3750 Metro - Dot1 X System-Auth-Control

2-93
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
dot1x system-auth-control
dot1x system-auth-control
Use the dot1x system-auth-control global configuration command to globally enable 802.1x. Use the
no form of this command to return to the default setting.
dot1x system-auth-control
no dot1x system-auth-control
Syntax Description This command has no arguments or keywords.
Defaults 802.1x is disabled.
Command Modes Global configuration
Command History
Usage Guidelines You must enable authentication, authorization, and accounting (AAA) and specify the authentication
method list before globally enabling 802.1x. A method list describes the sequence and authentication
methods to be queried to authenticate a user.
Examples This example shows how to globally enable 802.1x on a switch:
Switch(config)# dot1x system-auth-control
You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC
command.
Related Commands
Release Modification
12.1(14)AX This command was introduced.
Command Description
dot1x port-control Enables manual control of the authorization state of the port.
show dot1x [interface
interface-id]
Displays 802.1x status for the specified port.