Cisco Catalyst 3750 Metro - Debug Platform Phy

B-63
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Appendix B Catalyst 3750 Metro Switch Debug Commands
debug platform phy
debug platform phy
Use the debug platform phy privileged EXEC command to enable debugging of PHY driver
information. Use the no form of this command to disable debugging.
debug platform phy {automdix | flowcontrol | forced | init-seq | link-status | read | sfp |
show-controller | speed | write}
no debug platform phy {automdix | flowcontrol | forced | init-seq | link-status | read | sfp |
show-controller | speed | write}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform phy command is the same as the no debug platform phy command.
Related Commands
automdix Display PHY automatic medium-dependent-interface crossover
(Auto-MDIX) debug messages.
flowcontrol Display PHY flowcontrol debug messages.
forced Display PHY forced-mode debug messages.
init-seq Display PHY initialization-sequence debug messages.
link-status Display PHY link-status debug messages.
read Display PHY-read debug messages.
sfp Display PHY small form-factor pluggable (SFP) modules debug messages.
show-controller Display PHY show-controller debug messages.
speed Display PHY speed-change debug messages.
write Display PHY-write debug messages.
Release Modification
12.1(14)AX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.