Cisco Catalyst 3750 Metro - Mls Qos Srr-Queue Output Cos-Map

2-306
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
mls qos srr-queue output cos-map
mls qos srr-queue output cos-map
Use the mls qos srr-queue output cos-map global configuration command to map class of service
(CoS) values to an egress queue or to map CoS values to a queue and to a threshold ID. Use the no form
of this command to return to the default setting.
mls qos srr-queue output cos-map queue queue-id {cos1...cos8 | threshold threshold-id
cos1...cos8}
no mls qos srr-queue output cos-map
Syntax Description
Defaults Table 2-12 shows the default CoS output queue threshold map:
Command Modes Global configuration
Command History
Usage Guidelines The drop-threshold percentage for threshold 3 is predefined. It is set to the queue-full state.
queue queue-id Specify a queue number.
For queue-id, the range is 1 to 4.
cos1...cos8 Map CoS values to an egress queue.
For cos1...cos8, enter up to eight values, and separate each value with a
space. The range is 0 to 7.
threshold threshold-id
cos1...cos8
Map CoS values to a queue threshold ID.
For threshold-id, the range is 1 to 3.
For cos1...cos8, enter up to eight values, and separate each value with a
space. The range is 0 to 7.
Ta b l e 2-12 Default CoS Output Queue Threshold Map
CoS Value Queue ID - Threshold ID
0, 1 2 - 1
2, 3 3 - 1
4 4 - 1
5 1 -1
6, 7 4 - 1
Release Modification
12.1(14)AX This command was introduced.